Anything that interferes with the MAP sensor's ability to monitor the pressure differential may upset the fuel mixture and ignition timing. This includes a problem with the MAP sensor itself and grounds or opens in the sensor wiring circuit. Typical driveability symptoms that may be MAP related include surging rough idle a rich fuel condition detonation due to too much spark advance and a lean fuel ratio or loss of power and/or fuel economy due to retarded timing and an excessively rich fuel ratio. Eliminate these issues with a new OEM replacement quality MAP sensor.** Factory Replacement Part that Meets or Exceeds Original Manufacturer Specifications for the Vehicles Listed.2003-2004 Subaru Baja 2.5L 2458CC H4 GAS SOHC 2003-2004 Subaru Forester 2.5L 2458CC H4 GAS SOHC 2004-2005 Subaru Impreza 2.5L 2458CC H4 GAS DOHC Turbocharged2003-2004 Subaru Impreza 2.5L 2458CC H4 GAS SOHC 2003-2005 Subaru Legacy 2.5L 2458CC H4 GAS SOHC 2005 Subaru Legacy 2.5L 2458CC H4 GAS DOHC Turbocharged2002-2003 Mazda MPV 3.0L 183Cu. In. V6 GAS DOHC2000-2001 Mazda MPV 2.5L 2497CC V6 GAS DOHC1999-2005 Mazda Miata 1.8L 1839CC l4 GAS DOHC2004-2005 Mazda Miata 1.8L 1839CC l4 GAS DOHC Turbocharged2003-2004 Subaru Outback 2.5L 2458CC H4 GAS SOHC1997-1998 Mazda Protege 1.8L 1839CC l4 GAS DOHC1997-1998 Mazda Protege 1.5L 1489CC l4 GAS DOHC1997 Kia Sephia 1.8L 1839CC l4 GAS DOHC
S**Y
Made car unuseable, can't idle without stalling
Emissions troubleshooting article suggested cleaning or replacing the MAP sensor, which is generallyvery overpriced, and so I decided to try this very reasonable cost guaranteed to work replacement. Sincea pressure transducer is a very simple device that really shouldn't fail in the first place it was worth a try.Following installation directions results in the ODB codes being reset, and so starting fresh, the car went from idling and running well, to running rough and dying upon attempting to idle. Reversion to the old MAP sensor resulted in the engine running smoothly as before, with the addition of a new code regarding low barometric pressure.. This may clear itself, but the new sensor was simply unuseable since there is no way to incorporate it except drive cycles which are impossible to complete.
B**L
Doesn't work
Hooked up bolts in but engine shuts off 5 seconds after starting also tripped map code reinstalled old one and it runs again. I am changing sensors because it's time for new.
B**K
Caused car to stall. Stick with oem for Miata
2 stars because the seller was helpful but the part doesn't work as it should
K**2
Quality correct part
The part fit onto the connector very tight .aftr installing my vehicle continued to stall out.
M**L
Map sensor
It's not working rite.
C**Z
Five Stars
GOOD..
A**R
Great seller
Perfect fit, great price and quick shipping!
Trustpilot
2 weeks ago
3 weeks ago
