Ultra-Small RPi GPIO Terminal Block Breakout Board Module, for Raspberry Pi

An excellent product, well made and very useful, and I recommend it particularly as it leaves the camera connection unencumbered, unlike the breakouts which cover the entire board. However, as the screw threads of the standoffs are not something one typically has on hand, they should provide four additional screws and washers so that the Pi can be secured to a mounting board or box through the provided standoffs. Not a big deal, but the product's usability would be enhanced by this very small addition. (Note that even without screwing it down, the breakout board is solidly connected through its pins.)

What a study easy to wire connector. I needed a better way to wire my gpio on my raspberry pi. This is it. Comes with a screw driver that gits the screws to tighten the wires to individual gpio pins that you provide. I made a drivable car. The connector is well made and the wires are held in place solid once you screw them down. Once you get it installed it def is small but it is the correct size dor the gpio on tbe pi. With this i can wire my projects the unplug my pi, then go to another project and wire the next one up unplug pi when done as it plugs in like a hat connector.

The Chinese are getting better ...This is a very well made product in every regard, not the usual Chinese crap that eBay is too often flooded with. Despite the tiny size that is necessary to fit a credit card sized single board computer (SBC) like the Raspberry Pi 4, the terminal block is well made and the miniscule printing of the labels of each of the GPIO pin's function is crisp, sharp and legible.The included accessories are useful, saving customers the hassle to find/purchase a mini screwdriver for the little screws separately. The separators/spacer are brass instead of plastic and everything looks well made, allowing the GPIO connector on the Raspberry's PCB to still be used with straight connectors that you plug in vertically (angled connectors will obviously not be possible because the terminator block is on both sides).The little box with the product arrived three weeks earlier than expected.For anyone who plans on squeezing as many wiring as possible into the little Raspberry without buying a big housing, this little add-on is highly recommended.

The kit looks good and might work but didn't for me as I needed it ti fit close in a case. The overhang of the module was too far and then the wires wouldnt have access either. So if your using in a small case, measure first that you'll have enough room. Totally my fault but will use on another project. Love these RPis

Solidly built, well labeled and fits securely with the included standoffs. Terminals are very tiny (DuPont sized).Downside: the upper terminal block extends 4-5mm beyond the Pi 4B board edge and so will NOT fit inside tight enclosures or mounts. Does not fit it the small Canakit plastic case, nor on BeagleBone right angle DIN mount. Exchanged it for another hat which matches board dimensions.