Nilight 2PCS 16 AWG 10 Feet Wiring Harness Extension Kit for LED Work Light Bar Led Pods Off Road Lights Driving Fog Light Boat Lighting, 2 Years Warranty,black

Good value, inexpensive way to extend other wiring. Decent materials and seem close to OEM.

nice cables.... 1/4" spade fit tightly on speaker terminals. nice durable plastic covering. lay in the sun to warm up and they straighten right out

Extention works well with the light I put In bumper of my 2016 ford escape

Said they were a good fit for grand Cherokee but they are short. They could have been a foot or two longer. Wire is good quality and the plugs are good quality. I would buy them again.

This was ordered for making a custom wiring harness and the ends were terminated just as I needed them

Everything you need to extend or create a wiring harness for my side by side. Nice vinyl tubing to protect wires.

I had a set of 3” Nilight pod lights with wiring harness to install as rear lights on my Ranger 570 SP. The Nilight harness with relay was great! But it was too short to keep the relay and fuse in the front compartment on the pulse panel. These were the perfect solution!The extensions are plugged in under the tunnel to each of the individual light leads from the Nilight harness. And there was just enough length to run behind the seat back, up the driver side roll bar, and to each light. (Had about 1’ too much for passenger side light, so should be fine for full-size Ranger too.)Now have a weatherproof, factory quality installation with no splices or solder joints. The only mods I had to make for the entire install (not related to these extension cables) were: 1) Cutting the ring lugs off and adding waterproof heat shrink butt splices to Polaris pulse plug, and 2) Buying a factory-style Carling L1 illuminated switch to replace the round switch provided. (This is a direct plug and play too since the Nilight switch wiring has 1/4” faston connectors.)

Muy útil para instalar accesoriosBuena calidad