Table Saw Miter Gauge, Miter Bar Slider Table Saw Gauge Rod, Table Saw Accessories For Woodworking Tool Aluminium Alloy Saw Blades Sled Parts Accessories 300MM

It fits extremely well. No excessive up, down or side to side. No protrusion above the table height of my saw. I am extremely pleased!

It came with no documentation, which isn't a terribly big deal, but it has tapped holes and it would be nice to know what size screw to use so I don't have to purchase a whole assortment to test fit, or strip them trying the wrong size.But, the biggest and most critical complaint is they are too wide for a standard miter slot. I checked mine with a digital caliper and one runner was 19.05mm at the ends and 19.07mm in the middle. The other was a uniform 19.06mm. It's only a tiny bit too big, but it only takes a tiny bit too much material to make them useless.If I had known that I would have to grind the bars down to make them fit, I would have just fabricated my own to start with. If you don't have a way to accurately grind these down and also a mixed assortment of screws so you can attach them, do not buy them!!!

Didn’t match the picture or description

The bars fit great - I used two of these on my Sawstop for a small sled. The issue I had was that while holes for screws were pre-drilled, they were not countersunk - a must for this type of product. Fortunately, I was able to use a countersink bit to drill the holes in order to work for my application. I will not purchase these again, however, due to both my problem as well as the reviews from others leading me to believe quality control is non-existent.

The product I received did not look this the advertised part. The holes are not counter sunk, as shown. There are no lead rollers on the extremities, as shown. No instructions or explanations. I can c'sink the holes myself, and I can make it work without the rollers. It's a matter of principal. Stay away from this product and be weary of this seller.

The media could not be loaded.  This is not what is pictured based on selection. I selected the 300mm bar and the photo does no update. The one you get it’s actually over a few slides and lacks most of the holes and does not have the t-slot guides. Be cautious!

The two I bought were different widths. With a lot of work, I was able to file them down and think I was able to keep them accurate in this. Probably easier since I was using two of them. I would not have bought had I read the comments first. Who knew there would be issues with an aluminum bar?