SimbaLux Acrylic Sheet Black Opaque Cast Plexiglass 12” x 12” Square Panel 1/4” Thick (6mm) Plastic Plexi Glass Board with Protective Paper for Signs, DIY Display Projects, Craft, Easy to Cut

Bought a 12" x 12" x 1/4" sheet of acrylic to make new foot plates for my trim router as the original factory foot plate is too basic and its center hole is too large for standard guide bushings to be fitted.The sheet arrived well-packaged in bubble wrap inside a form-fitting box inside a larger Amazon box, which also contained some Forstner drill bits I needed for this project. It measured 1/16th under the 12 inches on both sides. I assume that the original large sheet is marked at exactly 12 inches and the cutting blade running along that line has a width of 1/8". Hence the loss of the 1/16th inch per cut sheet. Not an issue for my project, but would be if someone wanted exactly 12" square.The brown paper protection was ideal for marking out the sheet and it was left in place until all cutting, sanding and drilling was completed. I was able to power sand the acrylic up to the lines on the paper without the paper coming loose or fraying.The acrylic cut cleanly with my table saw (40 TPI), jig-saw and it was center-punched and drilled cleanly on my drill press (1700rpm) without cracking or melting.In conclusion, I do not hesitate to recommend this product.

Delivered quick and worked perfect for my project.

As advertised. Smooth transaction.

Used it to cut a piece about 6x6 to cover a dryer vent to keep little critters out while we aren't using the washer/dryer. Worked perfectly!

Used a small bandsaw to cut. It cut easily. Sturdy, thick, would buy again.

I ordered the black version of this sheet, it's definitely pitch black and very sleek~It feels bad calling this a mere sheet, it is quite thick but not to the point where it's heavy (held in my hand). It needed to be cut and rendered into a palette that wouldn't bite of course, and the process was nice and easy with no snapping or anything. Just some cutting and sanding and it was all done in 10 minutesThe palette loves to eat dust or something, but that's alright, it's not the sheets fault I don't think.Scratches pretty easily. These are simply puny scratches from a palette knife, so I will no longer be abusing my palette with a knife.I absolutely love the end product though,, and I'm sure the problems I encounter are due to the fact that I transformed the sheet into something meant for more than display

Household Project

This piece of plexi is clear and heavy for taking pictures of passports etc.